PERCo FP-01C, Инструкция по эксплуатации

Страница: 5 / 21

FP-01C Front panel for ST-01 Speed gate
5
5 INSTALLATION
5.1 Installation instructions
Attention!
The ST-01 speed gate installation instructions
– see in the
ST-01 Operation Manual . Take
into consideration that overall length of the speed gate with the FP-01C panel installed
increases by 68 mm (see Fig. 1).
FP-01C panel should be installed on the ST-01 speed gate instead of the standard front panel (see
Fig. 1 and ST-01 Operation Manual , Sect. 8.9.2). Before mounting (removing) the panel it is
necessary to remove the glass cover from the turnstile (see ST-01 Operation Manual , Sect. 8.9.6).
FP-01C panel arrangement is shown in the Fig. 3. Then the position numbers are arranged
according to the Fig. 3.
Figure 3. FP-01C Front panel
1
– card slot; 2 – front end indication module; 3 – container lock;
4
– container; 5 – panel fixing hooks; 6 – built-in reader
1
7
– connection cable of module with indicators
1
; 8
– cable for connecting the reader
1
;
9
– power supply cable for the card capture reader
1
; 10
– control cable for the card capture reader
1
1. Unpack the panel. Install the built-in reader inside the panel, if needed. The installation location
is shown in the Fig. 3. To install the reader, use the double-sided tape.
Attention!
Proximity card reader is not included in the delivery set!
It is possible to install not only PERCo readers ( IR13 , IR19 , IR03.1 , MR07 OEM , RP-15.2 ),
but also third-party ones.
Reader should comply with the following technical requirements:
- overall dimensions (length - width - height) .................... not more than
155×68×28
mm
- identifiers reading range .............................................................. not more than 40 mm.
1
Not included in the delivery set.