PERCo FP-01C, Инструкция по эксплуатации

Страница: 4 / 21

Certificate & Operation Manual
4
Parameters of control signals:
" Capture card " INPUT is controlled by the output of the ACS-controller, "dry contact" or "open
collector" type. The input is "normally opened", i.e. activation of the input will be done by a control
signal the ACS-controller couples to the
GND (contact 4).
Parameters of input:
the voltage at the open contact regarding GND .............................................................
5±0.5 V
the voltage at the closed contact in regarding GND .................................... not more than 0.8 V
current through the closed contact ............................................................. not more than 1.5 A
"Card captured" and "Alarm" outputs
– "dry contact" type. Each of these outputs represent one of
the relay contacts. The other contacts of both relays are combined together for "COM" output
(contact 7). The outputs are "normally opened", i.e., the activation of each output will be its closure
with the COM contact.
Parameters of outputs:
the maximum voltage between the correspondent output and contact COM ....................... 42 V
the maximum switching current ....................................................................................... 200 V
Figure 2. Card capture reader control board
Card capture reader control board layout is shown in the Fig. 2. There are terminal blocks on the
board:
•
ХT1 – input of the card capture reader (INPUT and GND contacts).
•
ХT2 – outputs of the card capture reader
" Card captured" (OUT and COM contacts) and
" Alarm" (Alarm and COM contacts).
•
ХT5 – connector with RS-485 interface for wiring from the ACS-controller (A and B contacts,
PERCo controllers only).
•
ХT6 – connector for connection of the power supply of the card capture reader (PWR and
GND contacts).
•
ХT8 – connector for connecting the
PERCo reader of the card capture reader to the lines with
RS-485 interface (A and B contacts).
•
ХT9 – connection for the power supply of the reader of the card capture reader (+12V and
GND contacts).
4.3 Removal and installation of the card container
To take out the card container from the card capture reader, unlock the container lock , then by
pulling the key towards you, take out the container.
Installation of the container into the card capture reader should be done in reverse order.