Pepperl+Fuchs VBG-CCL-G4F, Руководство пользователя

Страница: 75 / 78

AS-i/CC-Link Gateway
Appendix: Displaying the Figure Display
Subject to reasonable modifications due to technical advances. Copyright Fuchs, Printed in Germany
Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
is
s
u
e
d
a
te
1
0
.1
2
.2
0
0
2
73
11 Appendix: Displaying the Figure Display
In the basic state of the configuration mode, the display shows one after the other
the addresses of all detected slaves at a rate of two per second. A blank display
means that the
LDS is empty, i.e. no slaves were detected.
In the basic state of the protected operating mode, the display is either blank or
displays the address of a faulty assignment (see chapter 6.3.2).
During manual address programming, the slave address display has a different
meaning (see chapter 6.4 and 6.5).
All displayed numbers that are bigger than 31 and therefore can not be interpreted
as a slave address are status or error messages of the master. They have the fol-
lowing meanings:
39 Advanced AS-i diagnostics: If a 39 appears on the display after
pressing the ’set’-button a short-time AS-i power failure occured.
40 The AS-i master is in off-line phase.
41 The AS-i master is in detection phase.
42 The AS-i master is in activation phase.
43 The AS-i master starts the normal operating mode.
51 CC-Link ASIC not ready.
70 Hardware error: The AS-i master’s EEPROM cannot be written to.
72 Hardware error: The PIC processor does not respond.
73 Hardware error: The PIC processor does not respond.
74 Checksum error in the EEPROM.
75 Error in the external RAM.
76 Error in the external RAM.
80 Error while attempting to exit the configuration mode: A slave with
address zero exists.
81 General error while changing a slave address.
82 The front panel operation is blocked. Until the next power-up of the
AS-i master the accessing to the device only from the host via the
interface.
83 Program reset of the AS-i Control programm: The AS-i Control pro-
gramm is just read out of EEPROM and copied into the RAM.
88 Display test while starting up the AS-i master
90 Error while changing a slave address in protected operating mode:
No slave with address 0 existing.
91 Error while changing slave address: Target address is already occu-
pied.
92 Error while changing slave address: New address could not be set.
93 Error while changing slave address: New address could only be
stored volatile in the slave.
94 Error while changing slave address in protected operating mode:
Slave has wrong configuration data.