4.
4.201
4
16
AS-i Safety Output Module with Diagnostic Slave
Address Assignment
7.
Address Assignment
The device offers three different types of AS-i addresses:
7.1
Programming the AS-i address of the safety output
2.
Set desired address by using the hand-held addressing device or AS-i Mas-
ter.
3.
Check programmed address by using the hand-held addressing device or
AS-i Master.
4.
Check slave’s ID code by using the hand-held addressing device or AS-i
Master. The code should be set to “F”.
5.
Check slave’s ID1 code by using the hand-held addressing device or AS-i
Master. Code should be the same as the tens-digit of the address.
Safety output
VBA-4E2A1A-KE3-ZEL/E2L/SEL monitors communication on the safety
address and switches based on the monitored data.
This address can only be programmed if the switches are set to ON /
PRG.
SEL
PRG
ON
RUN
Information!
The address must be tested as described in Section <Programming the AS-i address
of the safety output>.
4I input slave
One standard AS-i slave (AB slave) for polling inputs I1, I2, I3 and 1.Y1
This address can only be programmed if the switches are set to SEL /
PRG.
Diagnostic slave
One standard-AS-i-Slave (AB-Slave) for diagnostics and switching under nor-
mal operating conditions.
This address can only be programmed if the switches are set to SEL /
RUN.
SEL
PRG
ON
RUN
SEL
PRG
ON
RUN
Basic position
Programming and monitoring of the address of the safety output is done as described
here:
1.
Set the switches of the device to ON/PRG.
SEL
PRG
ON
RUN
SEL
PRG
ON
RUN
Содержание VBA-4E2A1A-KE3-ZEL/E2L/SEL
Страница 1: ...AS I SAFETY OUTPUT MODULE WITH DIAGNOSTIC SLAVE FACTORY AUTOMATION MANUAL...
Страница 19: ......
