Pentium SQ578, Руководство пользователя

Страница: 37 / 57

SQ578
4-9
Setting Description
Disabled
AMIBIOS test all system memory. AMIBIOS waits up to 40
seconds for a READY signal from the IDE hard disk drive.
AMIBIOS waits for .5 seconds after sending a RESET signal
to the IDE drive to allow the IDE drive time to get ready
again. AMIBIOS checks for a <Del> key press and runs
AMIBIOS Setup if the key has been pressed.
Enabled
AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a READY
signal from the IDE hard disk drive. If a READY signal is
not received immediately from the IDE drive, AMIBIOS
does not configure that drive. AMIBIOS does not wait for .5
seconds after sending a RESET signal to the IDE drive to
allow the IDE drive time to get ready again.
You cannot run AMIBIOS Setup at system boot, because
there is no delay for the
Hit <Del> to run Setup message.
4.4.4 Boot Up Num Lock
Set this option to Off to turn the Num Lock key off when the computer is booted so you
can use the arrow keys on both the numeric keypad and the keyboard. The settings are
On or Off. The default settings are On.
4.4.5 Floppy Drive Swap
Set this option to Enabled to permit drives A: and B: to be swapped. The settings are
Enabled or Disabled. The default settings are Disabled.
4.4.6 Floppy Drive Seek
Set this option to Enabled to specify that floppy drive A: will perform a Seek operation
at system boot. The settings are Disabled or Enabled. The default settings are Disabled .
4.4.7 PS/2 Mouse Support
Set this option to Enabled to enable AMIBIOS support for a PS/2-type mouse. Pins 2-3
of the PS/2 Mouse Selector jumper on the motherboard must be shorted together to
enable PS/2 mouse support. The settings are
Enabled or Disabled. The default settings
are Enabled.
4.4.8 Typematic Rate
This option sets the rate at which characters on the screen repeat when a key is pressed
and held down. The settings are
Slow or Fast. The default settings are Fast.