Pentium Third Serial Port Installation
CTC Parker Automation
3
4. Remove the back cover from the unit by removing the screws
that secure the cover.
5. Remove the Compact Flash (CF) card if applicable.
Important
Always make sure power to the PowerStation is turned off
when removing the CF card.
Reconfigure the System Support Card
The first step in adding a third serial port to the PowerStation is to
reconfigure the System Support card. The following sections
explain how to do this, including instructions for disconnecting
cables from the System Support card, and removing and reconfig-
uring the card.
Disconnect the Cables
Before you can remove and reconfigure the System Support card,
you must first disconnect some cables that are attached to the card.
Use the illustration below to find the cables and other components
mentioned in the following steps.
Video cable
Touchscreen
cable (P5)
Backlight
cable (P6)
Serial cable
Wide ribbon
cable
