Make sure that you turn off the power supply when connecting the cables of the pump
Please check the turning direction of three-phase motors following each connection. If this does not correspond to the
arrow on the motor two connections in the junction must be reversed. Every motor must be permanently grounded.
Connections which are not conform to the above mentioned safety instruction are not covered by the
warranty.
Section 6
Start / Operation
Starting the pump
•
Fill pump strainer with water to suction pipe level.
•
Lubricate the lid O-ring with silicone each time it is removed.
•
Energize the motor, the pump will prime. The priming time depends on the suction lift and distance from the pool.
Five minutes is a reasonable time.
•
Pump will not lift more than 2,5 meter (7 ft.). If pump does not prime, see troubleshooting guide.
Maintenance
The strainer basket should be daily removed and cleaned. Never operate the pump without its strainer basket.
Component
Check
Interval
Remarks
Warning pictograms
Visual check
Monthly
Replace if necessary
Water supply
Check lines and
connections
Monthly
Repair any damage immediately
Safety devices
Visual check
Monthly
Ensure correct
installation / refitting
General condition
corrosion
Visual check
Half-yearly
Look out for any damage of pump
Cooling ribs of electric
motors
Clean the cooling ribs to
maintain the cooling effect
Half-yearly
Electrical equipment
Check
Monthly
Rectify loose connections or
cables immediately. Have all faults
repaired by a qualified electrician
Preliminary filter housing
Check housing for dirt
Weekly
Remove all dirt thoroughly
O-Ring in preliminary filter
cover
Visual check
Half-yearly
Winterizing
•
Protect the pump from freezing.
•
Remove all plugs and drain the pump and all piping.
•
Store drains and plugs in the strainer basket.
•
Remove the pump to a dry and warm room.
•
Do not wrap the motor with plastic covering as condensation may damage the pump.
•
In installations where the pump cannot be drained, a 40% propylene glycol, 60% water solution will protect to -46°C
•
Do not use other anti-freeze solutions, these are all highly toxic and will damage the pump
.
Section 6
Servicing
Risk of electrical shock or electrocution
This pool pump must be installed by a licensed or certified electrician or a qualified pool serviceman in
accordance with all applicable local codes and ordinances. Improper installation will create an electrical
hazard which could result in death or serious injury to pool users, installers, or others due to electrical
shock, and may also cause damage to property. Always disconnect power to the pool pump at the circuit
breaker before servicing the pump. Failure to do so could result in death or serious injury to serviceman,
pool users or others due to electric shock. Read all servicing instructions before working on the pump.
DO NOT
open the strainer pot if pump fails to prime or if pump has been operating without water in the
strainer pot. Pumps operated in these circumstances may experience a build up of vapor pressure and
may contain scalding hot water. Opening the pump may cause serious personal injury. In order to avoid
the possibility of personal injury, make sure the suction and discharge valves are open and strainer pot
temperature is cool to touch, then open with extreme caution.
English
5
