GREAT WHITE
®
II Automatic Pool Cleaner Installation and User’s Guide
9
Disassembly
1. Remove swivel assembly (
Figure 15
) from the
top of the Great White
®
II Automatic Pool Cleaner
by turning it 1/4-turn counterclockwise and pulling
straight up on it.
2. Turn cleaner upside down. Remove 6 screws and
remove lower body assembly from shroud.
3 . Turn lower body assembly right side up. Unsnap
the 2 clips on the oscillator chamber cap (
Figure
16
); lift it off.
4. Pull the long gear shaft straight up (
Figure 16
)
by the blocks on the ends of the shaft. Hold the
seals in the oscillator and the blocks on the shaft.
The cam may interfere with the shaft mounting
post; if so, turn it slightly on the shaft until it
clears the post. The shaft assembly can now be
disassembled (
Figure 17
).
5. Slide the long gear shaft out of the oscillator (with
gears, complete); make sure that you don’t lose
the seals out of the oscillator which may fall out
at this point (
Figure 17
).
5A. Oscillator seals are replaceable.
5B. Ratchet gear set and long shaft are replaceable
as a unit.
6. Remove the set screw, short gear shaft, and
gears (
Figure 18
); be sure to keep the gears on.
7. With a small screwdriver (such as a jeweler’s
screwdriver), a pencil, or a pen point, depress
and remove the coil spring from the lift brush
mounting post (
Figure 19
). Replace the brush
and the spring if necessary.
8. The metal ratchet tab slides out of its slot
sideways; replace it by removing the center
brushes and sliding in a new ratchet tab until it is
flush with the edge of plastic holder (
Figures 20
and 21
). Replace the center brushes.
9. The brush ring pops out of the cleaner body for
easy replacement.
10. If you need to replace the bumper, turn the
shroud and bumper assembly upside down and
remove the two screws holding the bumper to the
shroud.
Locked
Twist CCW
1/4 Turn
Pull Straight
Up
"Click" at
this point
Swivel
assembly
Clip
Ocillator
Chamber
Cap
Block
Long Gear Shaft
Block
Cam
1. Slide metal ratchet tab
toward end of cleaner body
2.Slide metal ratchet tab
down through cleaner body
Figure 16
Figure 15
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Содержание GREAT WHITE II
Страница 17: ...GREAT WHITE II Automatic Pool Cleaner Installation and User s Guide 13 Vacpole MANUAL MODE WITH TELESCOPIC POLE...
Страница 18: ...14 GREAT WHITE II Automatic Pool Cleaner Installation and User s Guide NOTES NOTES...
Страница 19: ...GREAT WHITE II Automatic Pool Cleaner Installation and User s Guide 15 NOTES NOTES...