Pentair GREAT WHITE II, Инструкция по установке и эксплуатации

Страница: 9 / 20

GREAT WHITE
®
II Automatic Pool Cleaner Installation and User’s Guide
5
OPERATION
This section contains information describing the movement and operation of your Great White
®
II Automatic Pool
Cleaner, as well as tips for “fine-tuning” your pool’s valves and connections to optimize the cleaner’s cleaning ability.
Cleaner Operation and Movement
Clicking sound
This is the sound of the oscillator moving back and forth in the oscillator chamber. The best speed for it is about 500
oscillations per minute. The vibration created by the oscillator moves the bristles and the cleaner. If the oscillator is
running too fast, the cleaner will have a tendency to climb up the pool wall past the waterline, or “walk out of the pool”
and suck air. Reduce the speed by adjusting the vacuum regulator in the skimmer.
Movement around the pool
Random motion
– The cleaner will visit most spots in the pool within a six (6) hour period. It is not specifically
programmed, and cannot see the dirt you are seeing. It is a random motion pattern.
The cleaner was designed to spend most of its time in the deep end, where most of the floor and wall area exists.
During a six (6) hour period, the cleaner will visit the shallow end a few times.
Rotating motion – The cleaner will rise up on one side and pivot a few times per minute. This is normal and provides
the following:
1. Allows leaves that are being pushed or dragged along to be sucked up into the vacuum chamber.
2. Allows the cleaner to:
Change direction
Get out of corners
Get away from ladders
Submerge below pool water level
Get off of domed main drain covers
Picks up “big stuff”
The cleaner will pick up some debris so large that it may jam. Simply stop the pump and remove the debris from the
oscillator, or the swivel assembly.