TROUBLESHOOTING
Problem
Solution
Control valve fails to regenerate
Check for power outage and verify unit is plugged
in. Attempt to perform a manual regeneration. See
“SETTING TIME OF DAY AND INITIATING A MANUAL
REGENERATION”. If problem still exists, contact your local
water treatment professional.
Water does not feel or appear soft
Check salt in brine tank and ensure salt level is above
water level. If problem still exists, contact your local water
treatment professional.
Unit uses too much salt
Contact your local water treatment professional.
Loss of water pressure
Iron in conditioned water
Excessive water in brine tank
Other problems with the water
softener
Power Outage
Reset the Time of Day in the event of a power outage/
failure. See “SETTING TIME OF DAY AND INITIATING A
MANUAL REGENERATION”.
CARE AND USE OF YOUR BRINE TANK
Each time the softener regenerates, salty water (brine) is needed to recondition the media in the water tank.
The brine is pulled from the salt tank at a controlled amount. If the salt tank does not contain enough salt, the
brine is weak, the media will not fully recondition and untreated water will pass through. To ensure the highest
level of performance of your water conditioning system, please observe the following:
• Keep the brine tank filled with salt at all times. The salt level should always be higher than the water level
in the brine tank.
• Only use salt designed for water softeners. Other types of salt (rock or snow melting) may contain dirt
and chemicals that will affect the quality of your water and the performance of your water softener.
• Keep the brine tank covered.
• Empty and clean the tank every three years.
FLECK
3200 Series Electromechanical Timer Owner’s Manual • 7
