28
Connecting the Transceiver to the Power Center
SWITCH OFF AC POWER to the Power Center before making any connections.
To connect the Transceiver wires to the COM port on the Power Center circuit board:
BEFORE REMOVING THE HIGH VOLTAGE COVER PANEL FROM THE POWER
CENTER
ENCLOSURE
switch OFF the power at the house main circuit
breaker
box.
1. Switch OFF AC power to the enclosure at the main house panel circuit breaker.
2. Unlatch the front door latch and open the front door. Remove the two retaining screws from the High
Voltage Cover Panel and remove the panel.
3. Loosen the two retaining screws securing from the top edge of the Outdoor Control Panel. Fold
down the Outdoor Control Panel to access the circuit board sockets connectors for the electrical
connections. Remove the panel from the enclosure (see illustration below).
4. Route the four conductor transceiver connection cable into the lower plastic grommet, up through the
low voltage raceway
to the system circuit board.
EasyTouch
®
PL4/PSL4 Control Systems Power Center (front view)
High Voltage
Cover Panel Tabs
Retaining screws
(for High Voltage Cover Panel)
Front door
Slots for High Voltage
Cover Panel
Retaining screws
(for Outdoor Control Panel
Retaining
screws
(for Outdoor
Control Panel
Flip down the Outdoor Control Panel to access circuit
boards in low voltage compartment
Low voltage
raceway
