Pentair CFIGGEN20, Руководство пользователя, Страница: 23 / 27

21
Troubleshooting
Problem POSSIBLE CAUSE: SUGGESTED
ACTION:
Low or no chlorine
residual in pool
Sanitizer Output percentage set too low or off at 0% Increase Output
Level.
Insufficient run time Increase run time
to at least 1 hour
per 10° ambient
temp.
Heavy pool use, inclement weather, organic matter Activate Super CL
mode
or
chemically shock
pool.
Water chemistry issues:
Low Chlorine Stabilizer
Low salt in the pool (less than 2300 ppm)
Phosphates in pool
Nitrates in pool Contact pool
professional,
ensure
all
chemicals
The cell is dirty, clogged, or
Has excessive scaling or mineral build-up Remove Cell from
plumbing, inspect
and clean (see
p.13).
Low or no Chlorine
residual in pool
after recent
installation
Water chemistry was not balanced prior to system installation
and a high chlorine demand persists Contact pool
professional,
ensure
all
chemicals on p.6
are within range,
chemically shock
pool if necessary.
Red Inspect cell Led
is on It is time to clean the Electrolytic Cell. The Cell must be
cleaned
Cell efficiency has been greatly reduced Inadequate water
flow exists, or Cell
must be replaced.
Red Inspect Salt
LED is on Pool water salt is too low or too high, system is off. Less than
2300 or Over 6000 ppm Correct the
salinity level.
Red Inspect Salt Led
is flashing Pool water salt is low or high, 2300 PPM to 2500 PPM/4500
PPM to 6000 PPM 2300-2500, the system is still working
Correct the
salinity level.
No Power Fuse/Reset has tripped Check fuses on
power center
No AC Power to the power center Check the
connection
No Flow LED is on Incorrect installation Verify Sensor
probe correct
orientation
Sensor probe Ensure correct