Pentair 5600SXT Series, Руководство оператора

Страница: 15 / 28

DIAGNOSTIC PROGRAMMING MODE
Diagnostic Programming Mode Options
Abbreviation Parameter Description
FR Flow Rate Displays.the.current.outlet.flow.rate
PF Peak.Flow.
Rate
Displays.the.highest.flow.
rate.measured.since.the.last.
regeneration
HR Hours in
Service
Displays.the.total.hours.that.the.unit.
has.been.in.service
VU Volume.Used Displays.the.total.volume.of.water.
treated.by.the.unit
RC Reserve.
Capacity
Displays.the.system’s.reserve.
capacity.calculated.from.the.system.
capacity,.feedwater.hardness,.and.
safety.factor
SV Software.
Version
Displays.the.software.version.
installed.on.the.controller
NOTE:.. Some.items.may.not.be.shown.depending.on.timer.
configuration..The.timer.will.exit.Diagnostic.Mode.after.
60.seconds.if.no.buttons.are.pressed..Press.the.Extra.
Cycle.button.to.exit.Diagnostic.Mode.at.any.time.
Diagnostic Programming Mode Steps
1.. Press.the.Up.and.Extra.Cycle.buttons.for.five.seconds.while.
in.service.
2.. Use.this.display.to.view.the.current.Flow.Rate..This.option.
setting.is.identified.by.“FR”.in.the.upper.left.hand.corner.of.
the.screen.
3.. Press.the.Up.button..Use.this.display.to.view.the.Peak.Flow.
Rate.since.the.last.regeneration.cycle..This.option.setting.is.
identified.by.“PF”.in.the.upper.left.hand.corner.of.the.screen.
4.. Press.the.Up.button..Use.this.display.to.view.the.Hours.in.
Service.since.the.last.regeneration.cycle..This.option.setting.
is.identified.by.“HR”.in.the.upper.left.hand.corner.of.the.
screen.
5.. Press.the.Up.button..Use.this.display.to.view.the.Volume.
Used.since.the.last.regeneration.cycle..This.option.setting.is.
identified.by.“VU”.in.the.upper.left.hand.corner.of.the.screen.
6.. Press.the.Up.button..Use.this.display.to.view.the.Reserve.
Capacity..This.option.setting.is.identified.by.“RC”.in.the.upper.
left.hand.corner.of.the.screen.
7.. Press.the.Up.button..Use.this.display.to.view.the.Software.
Version..This.option.setting.is.identified.by.“SV”.in.the.upper.
left.hand.corner.of.the.screen.
8.. Press.the.Extra.Cycle.button.to.end.Diagnostic.Programming.
Mode.
Pentair.5600SXT.Softener.System..•..15