Pentair Pool Products Pool and Spa IntelliComm, Инструкция по установке и эксплуатации

Страница: 5 / 44

Section 4
Installing the IntelliComm enclosure
Install the IntelliComm enclosure at the equipment pad at a maximum of 15.24 m (50ft.) from
the IntelliFlo pump. Leave sufficient clearance on all sides of the enclosure. Be sure that the
communication cable from the IntelliFlo pump can reach the IntelliComm enclosure location.
The IntelliComm enclosure can be mounted on a wall or vertical flat surface up to 15.24 m
(50ft.) away from the cell controller.
CAUTION: The IntelliComm communication center must be installed more than 2.44 m (8 ft.)
from the pool edges.
Note: For IntelliFlo 4 pump operating instructions, see the IntelliFlo 4 User’s Guide.
Section 5
Mounting the IntelliComm enclosure
1. Using a medium flat blade screwdriver, loosen the two plastic screws on the front
cover and open the front cover.
2. Mount the enclosure on a flat surface such as a wall or post. Mark each mounting
screw hole location.
3. Drill four 6 mm (1/4 inch) holes. Install anchors if necessary and one screw for each
enclosure hole.
4. Position the enclosure in place over the holes and install the four mounting screws
into the enclosure screw holes. Tighten the four screws to secure the enclosure.
Mounting screw access hole
Enclosure retaining screw
Enclosure retaining screw
Mounting screw access hole
English
5