4
IntelliFlo
®
Pump Demo Kiosk Operation and Set-Up Instructions
Installing Gray PVC Piping (Outside Cabinet)
Suction Section
1. Before installing, find the
gray gasket and install into the pipe flange.
2. Place the lower end of the Pipe into Hole #1.
3. Connect to the front threaded union adapter of the pump.
Discharge Section w/ Flow Valve
1. Locate the large
clear gasket and install into the available recess on the pipe flange end; flange must align (see
picture.
2. Locate and install (may already be installed) the Tassel Flow Assembly into the clear pipe end of the assembly.
3. Start by placing the tasselled end into the opening and continue by pushing into the pipe until the metal ring is
flush out inside the gasket (see picture).
4. Shake the pipe slightly to allow the tassels to be visible inside the clear section of piping.
5. Place the bottom end of the pipe into Hole #2.
6. Connect to the top threaded union adapter on the pump. Tighten the union nut securely, be sure pipe is centred in
Hole #2.
–
Note: Be sure gaskets do not fall off during assembly of discharge and suctions pipes - the pump will leak.
TIP:
Be sure flanges
of union and
gasket are
flush before
tightening the
union nut.
Hole #2
Installing the Piping
Light gray
gasket
Hole #1
