Pentagram Cerberus Wi-Fi Lite, Инструкция по установке и эксплуатации

Страница: 23 / 64

Cerberus Wi-Fi Lite (P6381-0)
23
• •• •
Setup Wizard: Wireless Basic Settings
Configure basic wireless LAN and wireless security settings in the fourth Setup Wizard
screen.
Band – If your wireless network contains only IEEE 802.11b devices, select 802.1 B .
If your wireless network contains only IEEE 802.11g devices, select 802.1 G .
If your wireless network contains both IEEE 802.11b and IEEE 802.11g devices, select
802.1 B/G .
Mode – In addition to setting the Wireless-G Router as an AP (access point) bridging the
wireless and wired networks, you can also set the Wireless-G Router to other operating
modes.
•
The Client mode allows you the use the Wireless-G Router as a wireless adapter
for a computer. This allows the computer to connect to a wireless network.
•
To wirelessly bridge two wired networks, use the WDS mode.
•
Select AP + WDS mode to set the Wireless-G Router to wireless bridge two
networks and work as an access point at the same time.
Network Type – This field is applicable when you select Client in the Mode field. Select
Infrastructure to allow a computer to connect to a wireless network via an access point.
Select Ad-hoc to allow a compute to connect to another wireless-enable computer.
SSID – An SSID uniquely identifies a wireless network. All devices in a wireless network
must use the same SSID to communicate with each other. Enter the name of a wireless
network to which the computer connects.
Channel Number – A channel is the operating frequency in which a wireless device
transmits data. The number of channels you can select varies depending on your
country’s regulation. Select a channel number the Wireless-G Router is to use for
wireless communication. To reduce interference, select a channel number that is further
away from what the nearest wireless device/network uses. For example, if the nearest
wireless device/network is using channel 6, set the Wireless-G Router to use channel 11.
Cancel – Click Cancel to start configuring the Setup Wizard again.
<<Back – Click <<Back to discard the changes and go back to the previous screen.
Finished – Click Finished to save the settings. The Wireless-G Router will reboot to
make the changes take effect.