PENSOTTI PCI 18, Инструкция по эксплуатации

Страница: 21 / 70

INSTALLATION INSTRUCTIONS
18
3.3 Installing the
combination water heater.
The appliance must be installed
exclusively on a vertical solid wall
capable of supporting its weight.
■ The combination water heater should
be fitted within the building unless
otherwise protected by a suitable
enclosure i.e. garage or outhouse.
(The combination water heater may be
fitted inside a cupboard)
■ /If the combination water heater is
sited in an unheated enclosure then it
is recommended to leave the ON/OFF
switch always in ON position to give
frost protection.
■ If the combination water heater is
installed in a room containing a bath or
shower reference must be made to the
relevant requirements.
■ Appliance is approved for installation
on combustible walls.
In order to allow access to the interior of
the combination water heater for
maintenance purposes, it is important
that the minimum distances indicated in
figure 1 are respected. To make the
installation easier, the boiler is supplied
with a template to enable the pipe
connections to be positioned prior to
fixing the appliance to the wall.
To install the boiler, proceed as follows
(see fig. 2):
a.
Use a level (of not less than 24” long)
to mark a horizontal line on the wall
where the boiler is to be fitted.
b. Position the top of the template along
the line drawn with the level,
respecting the distances indicated.
Then mark the centres of the
positions of the two wall screws or
anchors. Finally, mark the positions
of the water and gas pipes.
c. Remove the template and install the
domestic hot and cold water pipes,
the gas supply pipe and the central
heating pipes using the fittings supplied with the boiler.
Fix the boiler to the wall using the bracket and connect the pipes.
Fig. 1
MINIMUM DISTANCES [INCHES]
H
A
X
L
Y
Model X Y L H
40 17.7 2.5 2.5
B
A B
12 PCI 18/8 14
Fig. 1
Fig. 2