PENSOTTI DK2 Series, Инструкция по установке и эксплуатации

Страница: 36 / 42

Pensotti Heatline Quatech Series
31
8) Seal with a weatherproof sealant around the bead and edge of the outer wall plate to prevent
water from getting inside.
Connections To Outside Terminal
Using Figure 16 and Figure 17 complete the following steps:
1) Slide the inner section over the vent pipe.
2) Connect the terminal adapter to the vent pipe as
per joint assembly.
3) Apply a bead of sealant around the terminal flue
collar.
4) Slide the appliance adapter over the flue collar.
5) Tighten the gear clamp of the terminal adapter
around the flue collar.
6) Seal the seam in the adapter with sealant.
7) Slide the inner section over the outer section
and secure by tightening the gear clamp.
8) Stretch the air intake flex to the desired length
Figure 14
and slide over the air intake collar. Seal the connection with the aluminum tape and secure using
air intake clamp. Beaded end of the air intake clamp should go first over the air intake collar.
9) Seal the gap between the vent pipe and the inner section
with silicone sealant.
Connections To Appliance
Using Figure 18 , Figure 19 , Figure 20 and Figure 21
complete the following steps:
1) Connect the appliance adapter to the vent pipe as per
joint assembly.
2) Apply sealant around the appliance flue collar.
3) Slide the appliance adapter over the appliance flue
collar.
4) Tighten the gear clamp of the appliance adapter around the flue collar.
Figure 15
5) Seal the seam in the adapter with sealant.
6) Install burner air adapter.
7) Slide the end of air intake flex over the burner air adapter. Seal the connection with aluminum
tape and secure using air intake clamp. Beaded end of the air intake clamp should go first over
burner air adapter.
8) A vacuum relief device may need to be installed if required by the appliance manufacturers'
installation instructions.