PENSOTTI DK2 Series, Инструкция по установке и эксплуатации

Страница: 28 / 42

Pensotti Heatline Quatech Series
23
CRANKCASE OIL, WASTE OIL, OR GASOLINE
SHOULD NEVER BE USED!
The danger of explosion and personal injury is VERY HIGH when GASOLINE is present in fuel
source!
Never attempt to burn garbage or paper in the heating unit and remove all paper and rags from
around the unit.
For your safety, do not store or use gasoline or other flammable vapors or liquids in the vicinity of
this or any other heating appliance.
Start Up Procedure
•
Make certain service switch is off.
•
Check all fittings and wiring.
•
Be certain the boiler and heating system are completely filled with water. Purge all air
from system and ensure that proper system pressure is obtained. Twelve (12) PSIG-
Minimum.
•
Make certain that correct voltages have been applied to all circuits.
•
Check to make sure that oil storage tank is filled with clean #1 or #2 heating oil.
•
Make sure that all manual shutoffs are open in the system.
•
Set operating controls to desired or recommended settings.
•
Following the burner manufacturer's instructions set the oil burner for proper light off
and starting. Using accurate combustion test equipment set the burner for proper "steady-
state" operation. Use of instruments is necessary to ensure proper operation and to
achieve maximum efficiency that will yield the lowest possible fuel and operating costs.
•
Leave all consumer information, the burner manual, the control manual and this manual
on the job. Make sure your customer is aware of them.
Testing Safety and Control Devices
After installation and while performing maintenance the following procedures should be
accomplished: