PenMount Touchscreen 6000, Инструкции по установке

Страница: 25 / 55

Chapter 3 Installing Drivers for 6000 Boards
19
Use the following list to detect PenMount:
COM1 (Base 03F8) (Baud 19200): IRQ 3, 4
COM2 (Base 03F8) (Baud 19200): IRQ 3, 4
COM3 (Base 03F8) (Baud 19200): IRQ 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15
COM4 (Base 03F8) (Baud 19200): IRQ 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15
COM1 (Base 03F8) (Baud 9600): IRQ 3, 4
COM2 (Base 03F8) (Baud 9600): IRQ 3, 4
COM3 (Base 03F8) (Baud 9600): IRQ 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15
COM4 (Base 03F8) (Baud 9600): IRQ 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15
If you cannot find the PenMount, come 'configure' to set your COM port.
5. Configure
COM Port: COM5~COM9 is for setting customization.
IRQ no.: IRQ3~IRQ15
I/O base:
COM1~COM4 are fixed while COM5~COM9 are for
customization.
Baud: 19200 / 9600
Calibrate: left, right, top, and bottom point.
POMODE: the relationship between touch panel and monitor.
Beep Duration: beep duration time (0ms~5500ms), 0ms = turn off the
beep
Beep Freq: beep frequency (20Hz ~10000 Hz)
Other configurations for customization in PenMount 6000:
. jitter threshold
. SSD threshold
. Z threshold
. pen-up threshold
. digital filter
Function Key:
[ESC] - exit
[Tab] - toggle the fields
[up] - increase value
[down] - decrease value
[right] - increase value by 100 (Beep Freq)
[left] - decrease value by 100 (Beep Freq)
[Enter] - save configuration and exit
6. Packet
By using this function, you can get the touch data. Simply touch the
screen and you will see the data gotten.
The output format is as follows: