PenMount Touchscreen 6000, Инструкции по установке

Страница: 22 / 55

Installing Drivers for 6000 Boards
Step 2 : Go to the working directory. (e.g. cd \TEMP)
Step 3 : Run the installation program 'install.exe" at DOS prompt.
Step 4 : The install.exe will lead you to complete the installation.
Step 5 : Restart computer (Recommanded)
or
press 'ESC' key and issue 'SET
PENMOUNT=<penmount_installation_path>' at DOS prompt.
Step 6 : Driver will be loaded after restarting computer.
Note:
1. Environment Variable
– PENMOUNT
The environment variable, PENMOUNT, is needed for PenMount driver
v2.10.
The installation program will put the command line 'SET
PENMOUNT=<penmount_install_path>' into the AUTOEXEC.BAT, like:
SET PENMOUNT=C:\PM2 (e.g. PenMount installation path is
C:\PM2)
The driver can't be loaded, if the enviroment variable is not configured
properly and the utility can't be run. Issue the command 'set' at DOS
prompt to check the environment variable.

Environment Variable - PATH
The installation program will put the installation path into the environment
PATH. You can run program in any working directory at DOS prompt
regardless of where the working directory is.
3.1.2. PenMount DOS Driver Functions
PenMount DOS driver offers several functions. You can change the settings
with the following utilities:
1. PM2 Panel
Run the batch file 'PM2.EXE'. Type the command at DOS prompt:
PM2
Before running PM2, you must remove PenMount driver or another
mouse driver, if you have installed one.
There are several functions to select, and the launch key is in brackets.
(e.g. press '2' key to do calibration)