28
Intruder Alarm Systems
The following configurations define possible solutions for intruder alarms. Like all
other alerts provided by the SMS-TEM-4, these should be disabled prior to you
entering the premises. This is easily accomplished by issuing the text command:
Alerts off
when leaving the premise, simply issue the text command:
Alerts on
Connecting to a PIR motion sensor
Commands
Send command text: Change input
?
to Sensor
Send command text: Make Sensor latching
Send command text: Make Sensor active open (most PIR are normally closed and go open
when activated)
When the unit detects movement you will receive the following text message:
“The input Sensor has been turned on and is now latched”
When the alarm has been triggered you can reset it by sending the txt:
Reset Sensor
If you want to connect a siren and/or flashing light to output1 then:
Send command text: Link Sensor to output1
Send command text: Change output1 to Siren
When the unit detects movement you will receive a text message and the siren and/or flashing
light will turn On.
“The input Sensor has been turned on and is now latched. Linked output Siren has also been
turned on”
When the alarm has been triggered you can reset it by sending the txt:
Reset Sensor
or the siren can be turned off by sending the command: Turn siren off
Note: The command: Reset sensor will still need to be sent to reset the system even though the
siren has been turned off (to unlatch the sensor Input).
SMS-TEM-4
Input 1 or 2
PIR Sensor
Batt +
+
Output
-
Batt -
Ezy Switch SMS-TEMP-4 Installation & Operation
Power to PIR
