Pelton & Crane Helios HL3CB, Руководство по установке

Страница: 7 / 44

7
053154 r17
ellIPse HelIos InsTallaTIon -
Pole levelInG aDjUsTMenT
Set Screw
(B)
Set Screw
(A)
WaRnInG: Before making any connections,
be sure all power has been disconnected.
Making connections while chair or unit is
connected to power source may result in
equipment damage or injury.
POLE LEVELING ADJUSTMENT
1. Begin by setting up the chair in its final location.
Remove poles and arm from shipping box. Leave the
strapping tape in place on the flex arm for now. Remove
packing on vertical pole only.
2. Take the lower ellipse pole and insert bayonet end into
the chair mount until fully engaged (Figure 1). Set screws
should be seated in chair mount holes and lower ellipse
pole will be supported on its own.
3. Attach levels on vertical posts, 90 degrees apart so they
will measure front to rear leveling and side to side leveling.
Use a hex tool to adjust front set screw (A) to level the
posts from front to back (Figure 2). Adjust the side set
screws (B) to level the posts from front to rear. When the
post is level in both directions, tighten bolt (C) to secure
the unit to the chair mount (Figure 3) (Make sure pole is
still level after tightening bolt).
4. Remove all remaining packaging and inspect the light
for damage.
5. Loosen the screws and slide out the tubing cover from
the underside of the chair mount (Figure 4).
Set Screw
(A)
Chair Mount
Set Screw
(B)
Bolt (C)
Bayonet
Bolt (C)
Tubing Cover
Screws
Figure 1
Figure 2
Figure 3
Figure 4
WaRnInG: This line is intended for low
voltage use only. Use of this line is at the
discretion of the end user.