Pelton & Crane Helios HL3CB, Руководство по установке

Страница: 39 / 44

39
053154 r17
1. Raise chair to highest position.
2. Ensure power is disconnected to the chair.
3. Remove existing power supply circuit board (note positions of wiring to
board).
( note: see schematic for 300 watt board).
4. Install new Helios compatible circuit board.
5. Disconnect power cable in PMU.
6. Replace power cable from chair base to PMU and install 120” signal cable
(3 wire).
7. Remove upper pole from PMU.
for 1500 PMU remove retaining clip on post inside PMU.
8. See PMU Light installation.
InsTRUCTIon foR UPGRaDInG sysTeM PosT MoUnT (PMU) lIGHTs
WITH PoWeR sUPPly In base of CHaIR
1. Raise chair to highest position.
2. Ensure power is disconnected to the chair.
3. Remove existing power supply from junction box
(note positions of wiring to board).
4. Install new Helios compatible power supply.
5. Disconnect power cable under chair seat.
6. Replace light power cord in chair umbilical and
install 120” signal cable (3 wire).
7. Remove upper ellipse light and power cable.
8. Remove lower ellipse pole.
9. Replace lower ellipse pole with new pole.
10. See Ellipse light installation.
InsTRUCTIon foR UPGRaDInG sysTeM ellIPse lIGHTs WITH PoWeR
sUPPly In jUnCTIon boX
300 Watt Wiring
Transformer Power Circuit Board
Black (top) ST15
Black (top) ST17
1 ST18
3 ST14
5 ST19
7 ST16
ORANGE ST5
YELLOW ST6
BROWN ST9
BLUE ST7
VIOLET/WHT ST3
BLUE/WHT ST2
BLACK ST1