38
39
|
BIKE ASSEMBLY
BIKE ASSEMBLY
CONTINUED
1
Fit the handlebar post onto the handlebars. Make sure the letters on the post will be
upright when the handlebar is right-side-up.
2
Add two flat washers and two M8×12 round head screws to the front of the
handlebar base. Screw them in with a 5mm Allen wrench.
3
Add two flat washers and two M8×10 round head screws to the sides of the handlebar
base. Screw them in with the 5mm Allen wrench.
4
Loosen the L-handle at the front of the bike frame and slide the handlebar
post into the head tube.
1
3
2
4
5
Add an M5×15 Phillips head screw to the hole at the end of the handlebar post.
Screw it in using a Phillips head screwdriver.
6
Raise the handlebars to seat height and tighten the L-handle.
7
Take four M5x12 round head screws and add one flat washer and one spring
washer to each.
8
Secure each weight holder to the seat slider using two screw-and-washer sets and
a 4mm Allen wrench.
7
5
8
6
