pellenc HELION POLE TELESCOPIC, Руководство пользователя

Страница: 19 / 22

19
Repaired by
User
Approved PELLENC
distributor
Approved PELLENC
distributor
User User
Stop, then restart the battery and refer to the "T
ool does not start" paragraph if necessary
.
Solutions
Clean the guide pins
Tighten to 3.0N.m
max.
Change the casng
Reduce blade speed or pause for a while
Allow the tool to cool down for approximately 5
minutes
Checks
Check the condition
of the guide pins
Tighten to 3.0N.m
max.
Check the screw studs on the casing
Flashing diodes
The battery beeps 4
times
Probable cause
Clogged guide pins
Tightening of blade
screw
Broken casing
The tool is close to its temperature limit
The tool has reached its temperature limit
Condition of diodes
On
Flashes
O
ff
Condition of the battery on/off
switch
I I I
Symptoms
The blade makes an
unusual noise and/or of
f-
load consumption exceeds 200Wh after 1 minute of
operation
The diodes flash during use
The tool stops during use
INCIDENTS