IMPORTANT NOTICE
Because all construction must anticipate some water infiltration, it is important that the wall system
be designed and constructed to properly manage moisture. Pella Corporation is not responsible for
claims or damages caused by anticipated and unanticipated water infiltration; deficiencies in building
design, construction and maintenance; failure to install Pella products in accordance with Pella's
installation instructions; or the use of Pella products in wall systems which do not allow for proper
management of moisture within the wall systems. The determination of the suitability of all building
components, including the use of Pella products, as well as the design and installation of allow for
proper management of moisture within the wall systems. The determination of the suitability of
all building components, including the use of Pella products, as well as the design and installation
of flashing and sealing systems are the responsibility of the Buyer or User, the architect, contractor,
installer, or other construction professional and are not the responsibility of Pella.
Pella products should not be used in barrier wall systems which do not allow for proper management
of moisture within the wall systems, such as barrier Exterior Insulation and Finish Systems, (EIFS)
(also known as synthetic stucco) or other non-water managed systems. Except in the states of
California, New Mexico, Arizona, Nevada, Utah, and Colorado,
Pella makes no warranty of any
kind on and assumes no responsibility for Pella windows and doors installed in barrier wall
systems. In the states listed above, the installation of Pella Products in barrier wall or similar
systems must be in accordance with Pella's installation instructions.
Product modifications that are not approved by Pella Corporation will void the Limited Warranty.
Remove labels and clean the glass, using a soft, clean, grit-free cloth and mild soap or detergent. Be
sure to remove all liquid by wiping dry or use a clean squeegee. The vinyl frame may be cleaned as
described above. For stubborn dirt, a “non-abrasive" cleaner such as Bon-Ami
®
or Soft Scrub
®
may be
used. Do not use solvents such as mineral spirits, toluene, xylene, naphtha or muriatic acid as they can
dull the finish, soften the vinyl and/or cause failure of the insulated unit seal. Keep door tracks clear of
dirt and debris. Keep weep holes open and clear of obstructions.
CLEANING INSTRUCTIONS
