PELLA
®
INSYNCTIVE
™
BRIDGE PRODUCT GUIDE
|
9
VOLUME AND CHIME SETTINGS
BRIDGE uses lights and chimes to signal a number of changes
within the system such as unlocking or opening of a window
or door, successful sync or deletion of a device, or detection
of a fault. (A fault is an occurrence that interferes with the
regular operation and function of the device.) For more
information on faults, see page 12. For a complete list
of chimes, please see the Chime Indications Table below.
You can control the chime functions on BRIDGE by setting
small switches located in the battery compartment. With
the battery compartment door removed and BRIDGE oriented
with the plug at the bottom (see illustration), the bottom
two switches are S1 and S2 and the top two switches are
S3 and S4.
CHANGING CHIME SETTINGS
See
Insynctive.Pella.com/Support
for how-to videos.
Set the chime control switches to your preference using
the table below as a guide. Note that the chime switches
only control BRIDGE chime when a door or window is opened
or unlocked. If switches are set to No chime, BRIDGE will
not beep when a window or door is opened or unlocked.
However, it will continue to beep for other indications such
as successful sync or deletion of a device, during testing
of a device, or when a fault is detected.
VOLUME
S1 S2
Operation
on on
High volume (default setting
from factory)
on off
Med volume
off on
Low volume
off off
Volume controlled by Z-Wave
home automation system
CHIME
S3 S4
Operation
on on
Chime when window or door
is opened or unlocked
(default setting from factory)
on off
Chime when entry door is
unlocked
off on
Chime when window or door
is opened
off off
No chime
CHIME INDICATION TABLE
ADDITIONAL INSTRUCTIONS
PLUG
BATTERY
COVER
S1 S2
S3 S4
ON
OFF
ON
OFF
CHIME
CONTROL
SWITCHES
CLOSEUP OF
CHIME CONTROL SWITCHES
