R.
Cut a piece of flashing tape
to the width of the opening. Install to the flanges of the sill
SDQDQGRYHUODSWKHWDSHIURPVWHS1E\,IQHHGHGDGGDVHFRQGRUWKLUGSLHFHRI
flashing tape until the sill pan is covered to the interior sill pan lip.
Note: The purpose of this tape is to seal the sill screws when installing the door.
S.
Cut two pieces of flashing tape 1-1/2" x 6"
and apply to the bottom corners of the opening
by beginning in the corner of the sill pan, with
RIWKHWDSHDSSOLHGWRWKHVLOOSDQDQG
RIWKHWDSHDSSOLHGWRWKHVLGHŶDQJH7KH
UHPDLQGHURIWKHWDSHLVWREHDWDGHJUHH
DQJOHRQWRWKHH[WHULRU
1
ROUGH OPENING PREPARATION (continued):
T.
Attach the aluminum sill support or wood
blocking
WRWKHH[WHULRURIWKHER[SODWHWR
support the edge of the door sill. Place the sill
support flush with the subfloor.
2
PREPARE THE DOOR FOR INSTALLATION:
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL AND FRAME
SAFELY.
A.
Remove plastic wrap and cardboard packaging from door.
Do not remove plastic
shipping spacers. The shipping spacers will help keep the door square during installation.
Do not open the door until it is fully fastened.
Note: If grilles or hardware are removed from the door at this time, label them and store
them in a protected area.
B.
For doors without EnduraClad®
Brickmould:
Fold out installation
ŵQWRr%HFDUHIXOQRWWR
remove or tear the fin corners.
Note: If the fin corner is not
at 90°, the door will not align
correctly on the interior.
Note: The nail fin on doors with
brickmould and nail fin will
come from the factory folded up.
Ó
Door with
Brickmould
C.
Doors using Installation Clips:
Install
installation clips. Place each clip so
the lip is facing up and against the
installation fin at the locations shown in
the placement diagram. Secure each clip
E\GULYLQJD[FRUURVLRQUHVLVWDQW
screw through each of the outer two
holes of the three holes shown.
Note: If clips are to be bent; pre-bend
before attaching to frame.
Note: Bending clips after attaching to
frame will bow the frame.
6“ from end
Lip
#6 x 5/8” corrosion
resistant screws
2C
EXTERIOR SILL P
AN LIP
INTERIOR SILL P
AN LIP
1"
EXTERIOR SILL P
AN LIP
INTERIOR SILL P
AN LIP
1P
1T
1S
1R
