5
DOOR REPLACEMENT IN SIDING
WITHOUT NAIL FIN (continued):
D.
Clean the vinyl j-channel/trim and rough opening
with isopropyl alcohol or
window cleaner to make sure it is free of dirt and debris before proceeding.
E.
Place a 3/8" bead of sealant
(or enough to cover
the area) between the j-channel and the rough
opening at the head and jambs only. Tool the
sealant with a putty knife to press the sealant into
the opening.
CAUTION: The cut fin may have sharp edges!
'-"4)*/(5"1&
1-"$&.&/5(6*%&
4*--5"1&4
)&"%5"1&
+".#5"1&4
F.
Place a 3/8" bead of sealant
at each corner of
the opening.
PRESS
SEALANT
INTO
OPENING
HEAD
AND
JAMBS
ONLY
2B
2C
5E
5F
*
Starting at the top (head) of the opening,
cut
RQHSLHFHRIŶDVKLQJWDSHORQJHUWKDQWKH
width of the rough opening. Place the flashing
tape onto the j-channel edge, over the sealant
DQGRQWRWKHURXJKRSHQLQJVXUIDFHDQGH[WHQG
GRZQWKHMDPEV
H.
Cut two pieces of flashing
tape 6" longer than the height
of the opening.
On one side
(jamb) of the opening, start the
tape in the upper corner and
work down and onto the sill.
0DNHVXUHWKHWDSHLVDSSOLHG
from the j-channel edge over
the sealant and onto the rough
opening surface.
%
5G
For Sill Preparation see steps 1E - 1T.
5H
See steps 3A - 3F only for Setting the Door.
