F.
Check the interior reveal.
0DNHVXUH
the measurement from the interior face
of the door to the interior face of the
wall is equal at several points around
the door.
Note: If dimensions are not equal,
check to make sure the fins are folded
out to 90° at all points.
*
Fasten the door
WRRSHQLQJE\GULYLQJJDOYDQL]HGURRŵQJQDLOLQWRHDFKSUH
punched hole in the nailing fin.
Note: Make sure the fin corner is lying as flat as possible
H.
Carefully open the door(s)
and
remove all shipping spacers.
Note: Be sure to remove the
spacers from the bottom edge
of the door panel.
Double Doors with Multipoint latch in center:
Use the construction handle to operate
the active door handle. Operate the flushbolts per the instructions on the label on
the strike located on the astragal.
I.
Designer Series® Out-Swing:
Install sill screws. Place a dab of sealant in each
RIWKHSUHGULOOHGKROHVLQWKHERWWRPRIWKHXQLWVLOO7KHQLQVHUWD[
FRUURVLRQUHVLVWDQWVFUHZSURYLGHGLQWRHDFKKROH)RUPDVRQU\ŶRRUVXVD
PDVRQU\VFUHZLQSODFHRIWKHSURYLGHGVFUHZSLORWGULOOSHUVFUHZPDQXIDFWXUHUőV
recommendations.
All other:
Sill screws are not needed.
For combinations (Multi-wide):
3UHGULOOIUDPHDWPXOOLRQHQGV IURPHDFK
PXOOLRQMRLQWDQGLQVHUW[FRUURVLRQUHVLVWDQWVFUHZV)RUPDVRQU\DSSOLFDWLRQV
XVHPDVRQU\VFUHZV
J.
For Low Profile Sills:
7KURXJKHDFKLQVWDOODWLRQVFUHZKROHGULOODSLORWDQGLQVWDOO
D[FRUURVLRQUHVLVWDQWVFUHZSURYLGHGLQWRWKHSLORWKROHLQWRWKHŶRRU)RU
doors including a standard lock install tubs per instruction included with the sill strike
package.
Note: For concrete floors use masonry screws a minimum size of 3/16" diameter x 3"
and pilot per manufacturer’s recommendations for the screw.
3
SETTING AND FASTENING THE DOOR (continued):
Interior
3D
3D
3D
3E
1
2 0 3 0 40
5 0 6 0 70
2
3
INCHES
mm
3E
3F
3F
3E
3E
3E
3G
Clip or Frame Screw Installation,
go to Step 5I
