Installa on
and
Opera ng
Manual
Page
7
INSTALLATION
The drying cabinet is only designed for
operation indoors in a dry environment at a
temperature above freezing point.
The drying cabinet should not be installed in
a location where high pressure water is used
for cleaning.
LEVELLING
The drying cabinet should stand level on a
flat surface
,
resting on all four feet.
The feet can be adjusted using the toolbar through the
access holes in the base panel of the unit. Ensure that
the top edges of the doors are level.
ATTACHMENT TO WALL
Secure the cabinet to the wall using the screws, washers
and plastic plugs provided in the assembly kit.
1.
Open the door and drill two 8 mm holes into the wall
through the two pre-drilled holes in the rear panel of
the cabinet. Ensure any hidden water pipes or
cables etc. are avoided.
2.
Insert the wall plugs and, with the spacers and
washers provided, screw the cabinet back to the
wall.
3.
Fit the four plastic plugs to the base of the cabinet.
4.
Fix the pull handle to the door with the 4 x Torx
screws provided.
WARNING !
The drying cabinet should not be used without being
screwed to a wall due to the risk of it tipping forwards.
LOCATION AND FIXING
The drying cabinet should not be installed in a
location where any doorways or safety exits are
blocked when the door is open and the hanging
rails extended.
Ensure that the cabinet is fully pushed back to the
wall behind. If there are obstacles behind the unit e.g.
service or drainage pipes, contact your dealer for the
information bulletin on off-set fixing arrangements.
