Installa on
and
Opera ng
Manual
Page
12
DRYING PROGRAMMES
START THE PROGRAMME
LAST USED DRYING PROGRAMME
Press the main power
ON/OFF
switch. A green light should appear, indicating that the cabinet is on.
The display shows the most recently run programme. If this is the desired programme, press
START/STOP.
Or to select an alternative drying programme, follow the instructions below:
TO SELECT AN AUTOMATIC PROGRAMME
Press the
40
°
or
60
°
button as required, then press
START/STOP.
TO SELECT A MANUAL TIMED PROGRAMME
Using the
MAN
button, select between a
30°
,
40°
,
60°
, or
--°
(fan only) programme. The display
shows the standard drying time for each programme.
The standard time can be increased or decreased with the
+
and
-
buttons.
Once the required drying programme has been selected, press the
START/STOP
button.
DURING THE PROGRAMME
The revolving symbol on the display panel indicates that the drying process is in progress.
COOLING DOWN
During the 10 minute cooling down period, the display indicates “COOL”. The time is counted down
with the remaining minutes shown within the time field on the display screen.
END PROGRAMME
When the cooling down period is complete, the drying process is finished. The display screen will
flash “END”. When the
START/STOP
button is pressed, or the door is opened, the current
programme ends and the last completed programme is displayed.
STOP THE PROGRAMME
To discontinue a drying process that is in progress, press the
START/STOP
button.
INTERRUPTING THE PROGRAMME
If the door is opened when the drying programme is in progress, the display shows “CLOSE DOOR”
and a 5 minute countdown period begins. The heat is turned off but the fan will continue to operate.
If the door is shut within this 5 minute period, the current drying programme will continue as follows:
Automatic programme:
starts the drying cycle from the beginning, resulting in extended drying time.
Manual programme:
re-starts and counts down from the time of interruption.
If the door is left open, the drying process is discontinued and has to be re-started manually.
NOTE.
If power to the cabinet is not switched off within 10 minutes of the programme ending,
the display will go into sleep mode. To restore the display screen, press any button on the
control panel or open the door.
ADJUSTING THE DRYING PROGRAMMES
The drying cabinet’s two automatic programmes can be optimised in relation to the existing installation
conditions. This is done by adjusting the parameter values for the automatic programme concerned on
the control panel. This is only to be done if you find that:
The washing is not dried sufficiently or,
The washing is over-dried.
