PLUS
300 EXPERT
U THR
Pag. 28
USE AND MAINTENANCE MANUAL
Rev. 01-18
Each phase and the dripping are characterised by:
Temperature setpoint.
• Humidity setpoint.
• Refreshments enabling/disabling.
• High or low fans speed.
• Phase duration (maximum 99 hours with 30 min steps).
For the dripping phase it is possible to exclude the humidity and the cold management.
The program starts by pressing the START key for a few seconds, the program selection
and, therefore, the pressing of the SET key.
Program start:
1) press the START
key for a few seconds.
2) using the UP and DOWN arrows select the wanted program.
3) press the SET
key to start the program.
The time evolution is highlighted by the advancing bars. During program execution, it is
possible to amend the humidity and temperature setpoint directly from the keyboard
without having to access programming. Variations are provisional and do not alter the pre-
set program.
If a phase has 0 time, it moves on to the following one.
The times of the phases proceed even in case of no electric power supply or control stand-
by.
Using the START key (pressed briefly) it is possible to see the remaining time of the phase
in progress.
With parameter CIC, it is possible to program a cycle (once the program has finished it
automatically starts from the beginning) or to hook programmes between them, in order to
have a greater number of phases of the 6 of the individual program.
A program can always be interrupted by pressing the START/STOP
key for a few
seconds.
CHAP. 5 - Parameters programming
