2 of 18
ISSUED: 07-16-10 SHEET #: 061-9050-4 03-04-11
NOTE:
Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List ............................................................................................................................................................................... 3
Removing bay door ............................................................................................................................................................... 5
Wall installation .......................................................................................................................................................................7
Wall plate installation ............................................................................................................................................................. 8
Reinstalling door ....................................................................................................................................................................9
Attaching vertical brackets to screen ............................................................................................................................. 10,11
Mounting and removing screen ........................................................................................................................................... 12
Depth Adjustment ................................................................................................................................................................ 14
Setting Thermotstat ............................................................................................................................................................. 15
Filter Replacement .............................................................................................................................................................. 17
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• Due to outdoor environmental conditions such as strong wind gusts, heavy snow, hail, rain, etc. The environmental
enclosure and hardware, must be inspected at least once a year, and immediately following any time winds exceed
90 mph. A qualifi ed installer or inspector must check for signs of rust, loose fasteners, bent metal, etc. If evidence
of excessive wear, deterioration or any unsafe condition is observed, this product must be taken out of service
immediately. Direct all inquiries to customer care if you have any questions.
• Glass face of enclosure must avoid direct sunlight or damage to display may occur.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity. See page one.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud fi nder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product was designed for use with other outdoor products only
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
HARDWARE REQUIRED
•
Wood
Stud Included
•
Wood Beam
Included
•
Solid Concrete
Contact Qualifi ed Professional
•
Cinder Block
Contact Qualifi ed Professional
•
Brick
Contact
Qualifi ed Professional
•
Other or unsure?
Contact Qualifi ed Professional
WARNING
Tools Needed for Assembly
• stud fi nder ("edge to edge" stud fi nder is
recommended)
• drill
• phillips screwdriver, 5 mm allen wrench,
fl athead screwdriver
• 5/32" (4 mm) bit for wood stud wall
• level
• hammer
