Loudspeaker System Specifications
11
with local codes and regulations. It is also advisable to use a cable clip properly
affixed to the cabinet to strain relief the IEC power cord connected to the
amplifier module at (2) so the power cord cannot be pulled out or vibrate loose.
Use of the
PVX™p 15 Bluetooth® with a Subwoofer Pole Tunnel
The built-in stand mount cup allows use with the Peavey
XS™ series Subs and
the threaded pole that comes with those models.
Always be sure to place the subwoofer used in this manner on a flat, level and
stable surface.
Use of the
PVX™p 15 Bluetooth® with a Speaker Stand
The
PVX™p 15 Bluetooth® has a stand mount cup molded-in so that the system
can be stand mounted on a standard 1 3/8” (36mm) diameter stand pole.
When using stands or poles, be sure to follow these precautions:
Check the stand or pole specs to make sure that it can support the weight of the
PVX™p 15 Bluetooth® (50 lbs./22.7kg), and observe all safety precautions
stated by the stand manufacturer, including the maximum height the stand is
rated for.
Always place the stand on a flat, level and stable surface, and be sure to fully
extend the stand legs as per the stand
manufacturer’s instructions.
Try to make sure that the stand legs are oriented for the least danger of tripping
to those in the vicinity of the stand. Never block a doorway or hallway with the
legs of a stand.
Try to route cables so that people will not trip over them, or tip the speaker over.
Use of duct tape, cable channels or guards, or other appropriate tie-down/cover
–
up devices should be carefully considered and implemented.
When installing or de-installing the speaker on the stand, it is a good practice to
have a helper if possible, it can be hard to “thread the needle” and mate the
stand cup to the stand pole while holding the
PVX™p 15 Bluetooth® speaker
system at arm’s length. It is also helpful if someone holds the speaker stand and
pole down while the
PVX™p 15 Bluetooth® is removed from the stand pole, this
prevents the
PVX™p 15 Bluetooth® from pulling the pole up with it.
When using stands outdoors, never attach banners or flags to the stands or the
PVX™p 15 Bluetooth® speaker system, strong winds may cause the speaker to
blow over. If there is a possibility of windy conditions, then it may be prudent to
consider weighting or locking down the stand legs to prevent the
PVX™p 15
Bluetooth® speaker system from being blown over.
Connecting a Signal to the
PVX™p 15
There are a variety of ways to input a signal to the
PVX™p 15 Bluetooth®.
The inputs (4a and 4b) provides either a balanced mic- or line-level input,
allowing the use of a 1/4" TRS (ring-tip-sleeve) type phone plug or a male XLR
plug.
Do not connect cables to the jacks while the unit is ON and the Level knob is
turned up! While a standard single-ended 1/4" phone plug-equipped shielded
