(B)
Changing from battery saver mode to momentary and continuous strobe mode
Factory default activates battery saver mode. Follow below sequence to change function to momentary strobe mode.
To change to continuous strobe mode, repeat the above. Repeating it again will return you to battery saver
mode.
Note: You may activate either the strobe modes or the battery saver mode but not both at the same
time. Changing this function also resets the start up power setting to normal.
( C ) Setting how wide the beam will be upon power up
(D) Setting the power level the searchlight will start up in (after 3-5 second warm up)
(E)
Setting the smallest spot of the searchlight
Note: If you notice a delay before the lamp starts moving when moving out of the full spot position,
then the spot position was set beyond the point at which the lamp is physically able to move. If this
occurs, the spot position should be reset to a point at or within the physical limits of the lamp’s travel.
(F)
Setting the widest flood of the searchlight
Note: If you notice a delay before the lamp starts moving when moving out of the full flood position,
then the flood position was set beyond the point at which the lamp is physically able to move. If this
occurs, the flood position should be reset to a point at or within the physical limits of the lamp’s travel.
7
Set
spot position
To set light to start in battery saver mode
(also sets the left function to battery saver on/off)
To set light to start in normal mode
(factory settings)
To set light to start in strobe mode
(also sets the left function to continuous mode)
Set full
spot position
Set full
flood position
