hotspot of the beam.
5)
Repeat this procedure for the other adjustment screw.
6)
Replace the focus access screws when focusing is complete. Do not over tighten the screws, snug is
good enough.
Lamp Replacement
See instructions provided with MBA-2400 lamp replacement kit.
Programming
The Maxa Beam Searchlights provide you with a great deal of operational flexibility by allowing you to
modify the operational characteristics of the searchlight with some simple programming sequences. This
capability allows you to customize the light for the mission at hand.
As an example, if you want to use the light for an extended search operation in a wooded area, you could
set the light so that when it is turned on it will be in battery saver mode with a wide beam.
Other scenarios might be: a surveillance operation where you would want the light to come on in normal
power with a beam the size of the area under surveillance. Or, for a tactical, you could set it so that it would
come on in strobe mode with a wide beam.
When you receive your searchlight from the factory it will operate as follows:
It will come on in normal power mode.
Rocking the conditioning switch forward will narrow the focus of the beam.
Rocking the conditioning switch back will widen the focus of the beam.
Rocking the conditioning switch to the left will place it in battery saver (low power) mode.
Rocking the conditioning switch to the right will momentarily activate high beam.
To modify these characteristics follow the instructions shown on the following pages.
Explanation of symbols
= While the searchlight is running hold the red power switch down.
= Rock the beam conditioning switch in the direction show by arrow, then release.
= Release power switch, light will go out. New setting is saved
( A ) Changing High Beam from momentary to timed mode
Factory default activates high beam while the conditioning switch is held to the right. To change function
to timed high beam mode follow below sequence which will activate high beam for 16 seconds.
Repeating it again will return you to the momentary mode.
6
