7
(D) Setting Beam Intensity on Start Up (after 2 second warm up):
To set light to start up in low beam mode
(also sets left button to low beam mode):
To set light to start up in normal mode
(this is the factory default setting):
To set light to start up in strobe mode
(also sets left button to continuous strobe
mode):
(E) Setting the Smallest Spot of the Searchlight:
(F) Setting the Widest Flood of the Searchlight:
(G) Changing the Strobe Rate or Duty Cycle:
To follow this procedure the light must be in continuous strobe mode (see (B)).
(H) To Lock Out Programming Functions:
This will prevent modifications from being made to programming settings after they
are preset. To unlock use the Restore Factory Settings procedure in (I), below.
Note for (E) and (F): If there
is a delay between when the 4-
way switch is rocked and
when the lamp begins to move
after setting spot or flood
position, this indicates that the
spot or flood limit is set
beyond the point at which the
lamp is physically able to
move. If this occurs, simply
reset the spot or flood position
at or within the physical limits
of the lamp's travel.
