4
Searchlight Operation
1.
Locate searchlight, battery and power cable.
2.
Attach Searchlight
to Battery
by lining
up the four feet of the
searchlight over holes
in top of battery
(a)
.
Lower the searchlight
into the holes, then
slide the searchlight
towards the connector
end of the battery
(b)
until searchlight locks
in place. To detach
searchlight, lift the
Lock Release Lever
under the searchlight handle, then slide searchlight forward
away from battery connector end.
3.
Attach female end of power cable to 4-pin connector on searchlight
(c)
. Attach
male end of power cable to connector on battery
(d)
. To lock, rotate only the
locking ring clockwise. All connections are keyed; never force connections.
4.
If desired, attach a battery shoulder strap to diagonally opposite tabs on battery.
5.
To Turn Searchlight On
, press the red ON/OFF SWITCH. Searchlight starts
on high power, holds setting for 2 seconds, then drops to normal power.
6.
To Adjust Beam Width
, pull the black 4-WAY SWITCH back to increase
beam width to flood. Push the 4-way switch forward to decrease beam width to
spot. The default beam width on start up is 9 degrees. To set a different beam
width on start up, please see the Programming section of this manual.
7.
To Activate Strobe
, rock and hold the 4-way switch to the left. The default
setting is momentary strobe, which means that the searchlight will strobe when
the 4-way switch is held to the left. To set continuous strobe or low beam mode,
please see the Programming section of this manual.
8.
To Activate High Beam
, rock and hold the 4-way switch to the right. The
default setting is momentary high beam, which means that the searchlight will
stay on high beam when the 4-way switch is held to the right. To set continuous
high beam mode, please see the Programming section of this manual.
