Communication
Systems Inc.
PDI-P23LCDD Quick Start Guide
Page 3 of 8
Better Solutions Are Within Reach™
INSTALLATION INSTRUCTIONS
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH +1-937-743-6010 PH +1-937-743-5664
Document Number: PD196I148R1.DOC
LOCATION GUIDELINES
The model PDI-P23LCDD Hospital Grade LCD TV is a specialized LCD television. This TV is intended for entertainment
and educational purposes for use in a hospital, a nursing home, a medical-care center, or a similar health-care facility in
which installation is limited to a non-hazardous area in accordance with the National Electrical Code, ANSI/NFPA 70. The
PDI-P23LCDD is designed for mounting to PDI manufactured mounts. Installation of the TV on any other mount is not
recommended.
WARNING
: The TV’s VESA mounting
holes are designed for M4 metric screws
only. Use of a non-PDI approved mount or
SAE hardware could result in a condition
where the TV could unexpectedly fall and
cause injury or death.
The PDI-P23LCDD TV mounts at the foot of a patient’s bed with the supplied bracket. Select a location that is near an AC
wall outlet and that does not expose the TV to bright room lights or sunlight if possible. The LCD TV also requires
connection of both CATV cable signal and across-room wiring for the pillow speaker.
OSHPD (State of California Only)
The combined weight of the PDI-P23LCDD TV and PDI wall mount totals less than 20 pounds. At the time of this writing,
the involvement of a written, submitted, reviewed, and approved plan by OSHPD is not required to install the
PDI-P23LCDD TV in the state of California.
CABLE SYSTEM GROUNDING
The coax cable system connected to the PDI-P23LCDD TV should be grounded in accordance with the National Electrical
Code, ANSI/NFPA 70. The code provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.
The apparatus with Class I construction shall be connected to a mains socket outlet with a protective
earthing connection.
WALL MOUNTING WITH PD168-003 STANDARD WALL BRACKET
(Not supplied with TV)
1.
Refer to Figure 1. Select a location on the wall
approximately 8 inches below the ceiling.
NOTE: Do not locate AC, Across-Room Wiring, and
CATV Signal outlets below the Wall Bracket’s
location as it will cause clearance issues and
interfere with the TV’s cabinet when mounted to the
bracket.
Position the Wall Bracket and locate two mounting
holes. Secure the bracket to the wall (mounting
hardware is not included).
2.
Refer to Figure 2. Position the Back Mount on the
LCD TV cabinet. Attach with four M4 screws
provided.
3.
Mate the Back Mount to the Wall Bracket making
sure the pivot pins are retained in the “U” shaped
slot. Using the pilfer security driver packed with the
hardware, secure with two 10x32 pilfer screws.
4.
Connect the AC line cord, Pillow Speaker Jumper
Cable, and CATV Coax Cable.
5.
The TV’s tilt can be adjusted by loosening both Pilfer
Screws, adjusting tilt, and then tighten.
