Communication
Systems Inc.
PDI-P23LCDD Quick Start Guide
Page 4 of 8
Better Solutions Are Within Reach™
INSTALLATION INSTRUCTIONS
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH +1-937-743-6010 PH +1-937-743-5664
Document Number: PD196I148R1.DOC
ACROSS ROOM WIRING
A ¼” stereo style pillow speaker (pendant control) jack is located on the TV’s connector panel on the backside. This TV is
designed to work with either a digital pillow speaker that generates digital style control codes or a single-button analog
(switch-style) pillow speaker. A rear panel mounted switch allows use of different brands of pillow speakers and supports
the major brands; Zenith, Philips, and RCA pillow speakers.
WARNING:
DO NOT connect the pillow speaker circuit Common to earth ground.
Grounding of the Common will defeat the isolation circuitry of the television and
possibly expose the patient to harmful shock currents should a wiring fault occur.
Figure 2
Pillow Speaker Jumper
AC Power Cord
M4 x 6mm
Screws (4)
Pilfer Screws (2)
CATV Coax Connector
(Coax Not Shown)
Back Mount
Wall
Mount
Note: Make sure the
pillow speaker
selection switch
is set to the correct
setting before plugging in the jumper.
The switch changes the voltage supplied to
the pillow speaker, and could overdrive the
pillow speaker if incorrectly set
