SeeGull
®
HB
flex
TM
Reference Manual
PCTEL, Inc.
Page 22
Rev F
Figure 13 - IP Address and Subnet Mask
9. The default network configuration of
HB
flex
may be used for the PC’s IP
address and Subnet mask. It is
recommended to confirm with your
IT department. Enter numbers and
press OK.
Set Up Scanner:
After the IP address and Subnet mask are
confirmed for the PC, the scanner must be
assigned a corresponding IP address and
identical Subnet mask using SeeGull
Assistant. Please refer to the SeeGull
Assistant User Guide for more information.
Note: Consult Your IT Department to
Assign IP Address and Subnet mask for
the Scanner.
The IP address network identification must
be identical to the connected PC
’s IP
address. The IP address host cannot be
identical to the connected PC.
The subnet mask number must be identical
for both the scanner and connected PC.
Example:
PC:
IP Address: 192.168.2.
2
Subnet Mask: 255.255.255.0
Scanner:
IP Address: 192.168.2.
100
Subnet Mask: 255.255.255.0
IP Address Note:
192.168.2 is the network identification and
are identical for the PC and scanner.
The bold numbers are the host identification
and cannot be identical.
4.5. CDMA/EV-DO Holdover Operation
When a GPS signal is present, CDMA and
EV-DO technologies use the GPS data for
timing information to decode the signals.
With the Holdover option, the SeeGull
HB
flex
will continue to accurately decode
the pilots and cell IDs for a period of 4 hours
in the absence of any GPS signal. To get
the best performance of the Holdover option
during indoor measurements, we
recommend that the GPS be locked for at
least 30 minutes before using the SeeGull
HB
flex
scanning receiver in an unlocked /
holdover mode (with power maintained).
