VI. Replacing fuses
The power station is equipped with 3x 30A fuses. Should power station not operate properly, please check if fuses are blown.
Ensure that power station is turned off before replacing fuses.
VII. Connecting with an external storage battery
(for accessories please contact specialized electronic retailers)
Instead of the built-in battery, it is possible to use an external storage battery (11-15V) to operate your flash (the necessary external power cables (28+29)
are sold separately in electronics stores
*
). By using different battery capacities, you can adjust the power station to your requirements.
1. Connection with external battery
1. Make sure that the power station is turned off.
2. Connect battery unit with control unit.
3. Screw in the external power cables (28+29) into the input sockets (19+20). Please ensure correct po/-.
4. If the preceding steps have been performed correctly, you can turn on the power station.
*External power cables: no longer than 2m, allowing 100A current
Note:
• Ensure that plugs of control unit (16) and the external power output (22) of battery unit are locked properly.
• When using external battery, the built-in battery of power station will not be charged.
VIII. Maintenance and warranty
Wipe the mobile power station BP9000 with a dry cloth to clean it from dust and dirt. Any damages caused by improper use are not covered by the warranty.
Subject to change.
IX. Specifications
Content
1. PCP Mobile Power Station BP9000
2. Charger
3. AC power cable for charger
4. Case
Accessories optional:
PCP replacement or second battery for mobile power station BP9000
10
PCP Mobile Power Station BP9000
Instruction Manual
D
GB
Continuous output
750W
Peak power
1400W
Input voltage
11-15,5V
Output voltage/Frequency
AC 110V/60Hz or 230V/50Hz
Output Waveform
Pure Sine Wave
No-load current consumption
Normal mode:0,25A /
Flash mode:0,9A
High Harmonic Distortion
< 3%
Conversion Efficiency
91%
Low voltage alarm
yes
Low voltage shutdown
yes
Storage temperature
-30°C - 70°C
Operating temperature
-10°C - 45°C
Battery type
LiFePO4
Nominal battery capacity
12Ah (12.8V)
Charging time
approx. 3 hours
Fuse
3x 30A
Measurements
267 x 206 x 292 mm
Weight
approx. 6,8 kg
