OAFE-2000
IO&M Manual
Paragon Controls Incorporated
26
Revision Level 000
Measurement Type
Allows user to configure the device for Standard Flow, Actual Flow, Standard Velocity, Actual Velocity,
or Pressure measurement by toggle button. The selected System Measurement Type limits selection
of Engineering Units to only those applicable. Upon changing the Measurement Type, the Engineering
Units will start at the first applicable unit shown on the table below.
Engineering Units
Allows user to configure the device for the available engineering units shown in the table below by
toggle button. The appropriate units will only be made available depending on which measurement
type is selected. For example, if standard flow is selected, only standard flow units will be selectable
for that system. Changing the engineering units will not convert the values entered for Operating
Range or Alarms; new values will need to be entered in the correct units.
Default units is ACFM.
Standard Flow
Units
Actual Flow
Units
Standard Velocity
Units
Actual Velocity
Units
Pressure
Units
SCFM
ACFM SFPM AFPM In.
W.C.
SCFH L/S Sm/s Am/s Pa
SL/S
Am
3/
S
kPa
Sm
3
/S
Am
3/
M
mm
W.C.
Sm
3
/M
Am
3/
HR
Sm
3
/HR
Decimal Points (Significant Figures)
Allows user to change number of digits shown to the right of the decimal point. When a new
engineering unit is selected, the Decimal Point will be automatically updated according to the table
below. The user can then toggle through moving the decimal point to the left with each press of the
gray box.
Significant Figures
Units
000000. SCFM
SCFH
SL/s
Sm
3
/Hr ACFM AL/s Am
3
/hr
00000.0 Sm
3
/min Am
3
/min SFPM AFPM.
Pa
0000.00
mm
W.C.
000.000 Sm
3
/s Am
3
/s Sm/s Am/s
Inch
W.C
00.0000 kPa
5.2.9.
Δ
P Settings (Optional)
If the MTSE was configured at the Factory to include
Δ
P measurement points, i.e., pre-filter, final filter,
coils, etc., the following menu items and parameters will be available for user settings. This menu may
look different from your setup if the
Δ
P quantities were only entered for one or two points at the Factory.
Navigate to this menu from the Main Screen by pressing
Setup » 9.
Δ
P Settings
.
