© PCE Instruments
9
Notes:
•
The PCE-TTC 30’s memory and the internal clock/calendar use a small amount of
power although the calibrator is switched off. Remember to check the capacity of the
batteries from time to time although the PCE-TTC 30 is not in use.
•
Do not leave the PCE-TTC 30 without a Battery Pack or an Empty Battery for a long
time. The PCE-TTC 30 may lose its settings if it is left without a support voltage for an
extended period.
3
Start Up and Basic Operations
3.1
Power On or Off
To set the instrument power ON, press and release this button down until the display comes on.
During the power on sequence, the instrument shows a Startup Message and then shows the
applicable data.
To set the instrument power off, press and hold (≈ 2 seconds) this button again. When the power
is off, the last set of configuration options stays in memory.
3.2
User Interface
Every time the PCE-TTC 30 is switched on, the startup message ends in RUN Page. 3 display
modes are available in RUN Page.
1. TC Measure/Source Mode
2. EM Measure Mode
3. TC Measure/ EM Measure Mode
This Display Mode can be selected from MENU
→
DISPLAY Page.
In case of Dual Mode Display Screen is divided into two parts. Due to that only few additional info
will appear on RUN Page. The information to be shown can be selectable in Display Mode Menu.
3.2.1
The Status Bar
The status bar at the top of the display is visible only in RUN Page. It is divided into five main
sections.
