© PCE Instruments
27
After the start-up, the device w ill show w indow M01. This is the most common w indow und show s the
positive totaliser, the volume flow , the flow velocity, the signal strength, the signal quality and the
operating status, based on the values last set for the pipe.
4.3
Menu windows
M00 … M09
Window for volume flow , velocity, date, time, totaliser, battery voltage,
remaining battery life, etc.
M10 … M29
Window for pipe parameters, etc.
M30 … M38
Window for unit selection and totaliser
M40 … M49
Window for response time, zero setting, calibration and PIN protection,
etc.
M50 … M53
Window for data logger
M60 … M78
Window for date / time setup, display of softw are version and serial
number, alarm, etc.
M82
Window for total operating time
M90 … M94
Diagnostic w indow for better accuracy
M97 … M99
Commands for saving pipe parameters, diagnostic information and display
indications
M+0 --- M+8
Window for additional functions, including a scientific calculator, overviews
of operating hours, ON / OFF times,
…
The device has approx. 100 menu w indow s. These w indows are numbered from M00, M01, M02,
M03…, through to M99.
There are tw o w ays to select these w indows:
(1) Directly, using the MENU key and the tw o digits
(2) Via the Up / Dow n keys; each keystroke changes to the next higher or previous w indow ,
w hereas the w indow M00 is at the top, w hich means that the Dow n key w ill lead you to the
next higher w indow .
The device has three different types of w indows:
(1) Window to enter numbers, e. g. M11 to enter the pipe diameter
(2) Window to select options, e. g. M14 to select the pipe material
(3) Window s to view data, without being able to make a selection, e. g. M+1 to show the
complete operating time of the device
About (1): When you are in a w indow for data entry, you can enter the data and confirm w ith ENTER.
For example, if you are in w indow M11, you can directly enter
for the outer diameter of the pipe.
About (2): In a selection w indow , first press the ENTER key and then make a selection using the Up
and Dow n keys or the number keys if a number needs to be selected. Finally, confirm your selection
w ith the ENTER key.
Example M 14 (material selection):
Stainless steel, for instance, is assigned no. 1. To select a different material, press ENTER to be able
to make your selection using the Up and Dow n keys. Confirm your selection w ith ENTER. You can
also enter the numbers directly via the numeric keypad.
E
n
g
lis
h
