© PCE Instruments
7
•
Encrypt:
o
The default setting is none
o
Press the
◄ or ► button to select the value, then use the ▲
and
▼ buttons
to toggle between none / wep_open / wep / wpa_tkip / wpa_aes / wpa2_tkip
/ wpa2_aes / wpawpa2_tkip / wpawpa2_aes
o
Press the SETUP/ENTER button to confirm your change.
o
Press the
▼ button to move the selection to
Password.
•
Password:
o
The default password is 12345678
o
Press the
◄ or ► button to select the value, then use the ▲
and
▼ buttons
to input numbers or letters, after pressing the EXIT/SHIFT button.
o
Press the SETUP/ENTER button to confirm your change.
o
Press the
▼ button to move the selection to
IP
.
•
IP:
o
The default IP address is 192.168.0.254
o
Press the
◄ or ► button to select the value
and then
use the ▲
and
▼
buttons to input numbers for a new IP address.
o
Press the SETUP/ENTER button to confirm your change.
o
Press the
▼ button to move the selection to
Port
.
•
Port:
o
The default port is 200
o
Press the
◄ or ► button to select the value and then use the ▲
and
▼
buttons to input numbers for a new port (max. 65535 numbers).
o
Press the SETUP/ENTER button to confirm your change.
o
Press the
▼ button to move the selection to
Gateway
.
•
Gateway:
o
The default gateway is 192.168.0.1
o
Press the
◄ or ► button to select the value and then use the ▲
and
▼
buttons to input numbers for a new gateway.
o
Press the SETUP/ENTER button to confirm your change.
o
Press the
▼ button to move the selection to
Unit
.
•
Unit:
o
Press the
◄ or ► button to select the value,
and then
use the ▲
and
▼
buttons to toggle between C and F.
o
Press the SETUP/ENTER button to confirm your change.
o
Press the
▼ button to move the selection to
Default Settings
.
•
Default Settings:
o
Restore to factory settings (refer to point 5.6).
•
Press the EXIT/SHIFT ( ) button to save the changed settings. The device then needs
~25 sec. to reconnect (Screen 7 or 8) before returning to the measurement screen
(Screen 5 or 6).
5.5
Measurement and Wi-Fi connection
•
Screen 3 is the temperature and humidity measurement screen.
•
Pt1000 measurement mode
o
Insert the probe into the PT 1K input (Fig.1 3.18).
o
Press the
► button
to toggle between the PT1000 measurement screen
(Screen 4) and the Temp/Humidity measurement more (Screen 3)
•
A Wi-Fi symbol ( ) will flash in the upper, right hand corner of both measurement
screens to indicate an existing connection.
