Introduction
50
SmartNode 5541 & 4141 Series User Manual
C
• Cabling
Introduction
This section provides information on the cables used to connect the SmartNode device to the existing network
infrastructure and to third party products.
Ethernet
Ethernet devices (10/100/1000 Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SmartNode device are Auto-MDX. Use any straight or crossover cable to a host, hubs,
switches, PCs or other devices.
Note
Connecting both Ethernet ports to the same switch will only work if the
switch has a separate ARP table for each connection.
Figure 15. Typical Ethernet straight-through cable diagram for 10/100Base-T
Figure 16. Typical Ethernet straight-through cable diagram for 1000Base-T
The interconnecting cables shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
RJ-45, male
1
2
3
4
RJ-45, male
1
2
3
4
5
6
7
8
5
6
7
8
Содержание SmartNode 4141 Series
Страница 49: ...49 Appendix C Cabling Chapter contents Introduction 50 Ethernet 50 Analog FXS 51...
Страница 52: ...52 Appendix D Port pin outs Chapter contents Introduction 53 Ethernet 53 FXS port 53...
Страница 54: ...FXS port 54 SmartNode 5541 4141 Series User Manual D Port pin outs Figure 18 RJ 11 pinout diagram...
Страница 55: ...55 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 56...
