Planning the installation
27
OnSite 2800 Series User Manual
2 • Hardware installation
Planning the installation
Before you start the actual installation, we strongly recommend that you gather all the information you will
need to install and setup the device. See
table 3
for an example of what pre-installment checks you might need
to carry out. Completing the pre-installation checks enables you to install and set up your VPN router within
an existing network infrastructure with confidence.
Note
When setting up your VPN router you must consider cable length
limitations, and potential electromagnetic interference (EMI) as
defined by the applicable local and international regulations. Ensure
that your site is properly prepared before beginning installation.
Before installing the VPN Router device, the following tasks should be completed:
•
Create a network diagram
(see section
“Network information”
on page 29)
•
Gather IP related information
(see section
“IP related information”
on page 29 for more information)
•
Install the hardware and software needed to configure the OnSite router.
(See section
“Software tools”
on page 29)
•
Verify power source reliability
(see section
“Power source”
on page 29).
When you finish preparing for your VPN Router installation, go to section
“Installing the VPN router”
on
page 30 to install the device.
The mains outlet that is utilized to power the equipment must be
within 1 meter (3 feet) of the device and shall be easily accessible.
CAUTION
Содержание OnSite 2800 Series
Страница 112: ...112 Chapter 9 LEDs status and monitoring Chapter contents Status LEDs 113...
Страница 124: ...124 Appendix C Cabling Chapter contents Introduction 125 Serial console 125 Ethernet 10Base T and 100Base T 126...
Страница 132: ...132 Appendix E OnSite 2800 Series factory configuration Chapter contents Introduction 133...
Страница 134: ...134 Appendix F Installation checklist Chapter contents Introduction 135...
